NETGEAR Switch GS605AV 100NAS User Manual

GS605AV_IG_08Dec09.fm Page 1 Tuesday, December 8, 2009 7:53 PM  
4. Connect the power adapter cord into the back of the switch and then plug the adapter  
into a power source (such as a wall socket or power strip).  
Install the Switch and Connect the  
Other Devices  
)NSTALLATION 'UIDE  
5. Check the LEDs to confirm that the switch is connected correctly.  
5-Port Home Theater & Gaming Network Switch GS605AV  
The Power LED is lit.  
1. Place the switch on a flat surface.  
Estimated installation time: 5-10 minutes  
Each port on the back has associated with it a bicolor LED on the front.  
2. For each device, insert one end of an Ethernet cable into the port in the device and  
insert the other end into one of the Ethernet ports on the switch. If you have more  
devices to connect than the number of ports on the switch, connect the devices to  
another switch or hub and then connect that switch or hub to this switch.  
Green: 1000 Mbps link  
Amber: 10 Mbps or 100 Mbps link  
Blinking: Activity  
Package Contents  
The package includes:  
3. If you add devices using another switch or hub, make sure the QoS category of the  
devices match the GS605AV port used by the switch or hub.  
Note: If any light does not operate as indicated, go to the Troubleshooting section.  
5-Port Home Theater & Gaming  
Network Switch GS605AV  
Power adapter  
Installation Guide (this document)  
Warranty/Support information card  
Modem  
Prepare to Install the Switch  
Decide where you want to place the switch. Find a flat horizontal surface such as a table,  
desk or shelf.  
Power On/Off  
High Priority  
Medium Priority  
Low Priority  
Broadband  
Router  
Below is a possible GS605AV configuration. Connect either port 1 or 2 (yellow port) to  
the LAN port of your router. Connect your latency sensitive device (IP phone) to port 5  
(dark green port).  
GS605AV  
Make sure the selected location is:  
Not in direct sunlight or near a heater or heating vent.  
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on  
all sides of the switch.  
Well ventilated (especially if it is in a closet).  
Note: The switch is not designed to be stacked on top of other devices.  
Depending on the speed of your network devices, you need a Category 3 (10 Mbps),  
Category 5 (100 Mbps), or Category 5e (1000 Mbps) Ethernet cable with RJ-45  
connectors for each device you want to connect to the switch. Each Ethernet cable must be  
less than 328 feet (100 meters).  
High priority port: dark green  
Medium priority ports: light green  
Low priority ports: yellow  
r
Note: The GS605AV will optimize audio/video streaming prioritization if it can recognize  
the pattern. If the GS605AV cannot recognize the pattern, you still can use port-based QoS  
to manually configure priority for your devices.  
 

Miele Clothes Dryer T 1303 User Manual
Miele Dishwasher G 4570 User Manual
Miele Washer Dryer PW 5065 User Manual
NEC Network Card NDA 24233 User Manual
NEC Projector SX10000 User Manual
NETGEAR Network Router DG834PN User Manual
Nextar MP3 Player MA588 User Manual
Olympus Microscope Magnifier BX3 User Manual
Onkyo Stereo System T 4555 User Manual
Panasonic Router 324566 A User Manual